Cabinets and drawers

CARCASE
The carcase is made in 19-mm white 100-g melamine-coated chipboard and 6-mm back panel. All carcase parts are fitted with rounded PP edging. All cabinet front edges have dust seals to prevent dust from penetrating into the cabinet. The cabinets are assembled with glue and dowels.

Standard poison and chemical cabinets are supplied with an extract spigot and with the bottom drawn for air intake.

Underbench cabinets for fume cupboards are supplied with an extract spigot in the back and with the bottom drawn for air intake.

SHELVES 
Shelves are supplied in 19-mm 100-g melamine. The shelves have a big load-carrying capacity and may have additional support, as required. The shelves are mobile and have a surface quality which meets the requirements of DIN 68 763.

DRAWERS 
Drawers are detachable and tolerate high loads (35 kg per drawer). The drawers can be offered with a soft-close mechanism and a push-open function. Standard extension of 80%.

Worktops

Sink unit

The table below shows the combinations available when choosing the worktop type and sink.

Installations

Weighing column

The weighing column ensures optimal stability in order that precision measuring work can be executed in the laboratory. The weighing column is designed for precise measurements down to four decimal places, and its measuring is independent of the adjoining structure.

The weighing column’s design includes vibration damping, and it can either be freely positioned or set in a worktop with a section cut out for the weighing column/weighing stone.

The weighing column’s base plate is made from compact laminate and it is secured to the concrete floor using an expansion bolt. The weighing stone is made from granite.

The maximum load on the table is 100 kg and 17 kg on the road stone.

Point exhaust

The extraction arm is removable and designed as a self-bearing and flexible structure, which is easy to operate and clean. The arm can be adjusted with one hand, so that it extracts smoke, dust or gas as close as possible to the source of contamination.

SERVICE CHASE

The Labflex service chase is available either as wall-mounted or for island setups:

• Cable and pipe laying from ceiling to service bridge.
• Cable and pipe laying from ceiling to unit.
• Cable and pipe laying from ceiling to floor.

Standard width is 300 mm. Depth and height depents on the variant.
Front: Laminate, 18 mm with 3 mm ABS plastic edge band.
Sides: Melamine, 19 mm with 1 mm ABS plastic edge band.

The hatch at the bottom of the service chase provides access for the laying and servicing of installations.

Taps

Certified in accordance with ISO 9001 and Danish Gas Technology Centre (DG) approved. Colour codes on the handle are as standard in accordance with EN 13792.